Standard size shower base
The basis of the shower is the floor of the cabin shower. Usually this part has a height of 5 inches (12.7 cm) and a drain and is made to fit just within the walls of the shower. Some measures are standard for shower base; however, they can be manufactured as shower pan of any size.
Standard full shower
A complete standard shower usually measures 30 inches wide (76 cm) by 60 inches (1.5 m) long. This fits standard base in the bath or showers any standard home with some modifications in the shower walls. As always, flush strips which are long wood strips that function as wedges can be used to adjust the shower base in areas that are not exactly square.
Largest full shower
Some areas for the shower are larger than others. In larger showers, dimensions extend to the 42-inch (1 m) wide by 60 inches (1.5 m) long. The bathrooms and showers medium measured 36 inches (91 cm) wide by 60 inches (1.5 m) long, The base may be wider for those seeking to place a whirlpool Jacuzzi or larger. The basis of this long standard size will fit in these predetermined areas when a tub is not installed.
Many shower bases are smaller than full made to occupy the space normally occupied by a tub. These showers are built into bathrooms with limited space and may even occupy the space of what was once a closet. The square bases are usually from 32 (81 cm) by 48 inches (1.2 m) inches. The size depends around the shower and the available space in the bathroom. Find square bases, angled bases and even circular bases. Common sizes are 36 inches (91 cm) by 36 inches (91 cm) and 48 inches (1.2 meters) by 36 inches (91 cm).
Some bases have a rounded end. This configuration makes sense in small bathrooms where space is precious. A square base occupies more space than circular base and, as people usually do not use both corners, they do not provide much comfort. Round bases are standard size, with a width from 30 inches (76 cm) to 48 inches (1.2 m) on the sides; on the late side, the base is arched. The size depends on the width of the opposite side to the edge of the rounded side of the base.